Uses:
The coating prevents flame spread in conductors, when exposed to moderate fire sources that might occur from arc or sparks falling or occurring in the cable tray, or from fire exposure of combustible trash or foreign material around the cables in grouped or trayed conditions.
Quantity of Flammadur® A77HF Needed:
It takes 1.48 kg/m2 of spraying two coats of A77HF on cables, for dry coat of a mm
Safety Precautions:
Flammadur® A77HF is not designed to offer electrical insulation properties and since it is water based, when it is wet, it should not be applied to energized electric cables.
A waterproof protective varnish, film or plastic covering should be used when installed outside or in other damp areas
Before handling read the Material Safety Information.
Wear eye protection and suitable gloves.
Preparation:
Apply between 40oF (5oC) to 100oF (40oC)
Clean cables, which with the supporting structures, must be dry and free from the oil, grease, dust and paint.
Mix thoroughly in the pail. Any separated water in the pail must also be mixed. Do not add water.
|